Installing CA Gen on NonStop › Install the Setup Tool › Select Setup Tool Installation Options

Select Setup Tool Installation Options

The Setup Tool Install Menu lists options to select the installation steps.

Follow these steps:

1. Type the number or letter of an option to install the Setup Tool and its Pathway environment. The Setup Tool Install Menu lists the following options:

   1 = (step 1) create SETUP TOOL Pathway environment

   2 = (step 2) create SETUP TOOL Database

   3 = (step 3) create SETUP TOOL programs

   Important! If you select Step 2 to create the Setup Tool database, select Step 3 to create the Setup Tool programs. Using a newly installed database for the Setup Tool with previously installed and configured tool programs can result in unpredictable operation. A complete Setup Tool requires you to perform all three steps that are listed for a new installation.

   Or, type A to perform All Steps 1, 2, & 3

   • When installing the Setup Tool for the first time, use A to complete all steps in order.
   • To partially reinstall the Setup Tool, use one of the following methods to overlay a previous installation:
     • Select Step 1, then Step 3, and then enter E to exit. These steps replace the existing Setup Tool Pathway environment and Setup Tool programs, leaving the previously installed database intact, and preserving the target database information, including the history of every installation.
     • Select Step 1 to install the Pathway environment, then enter E to exit. These steps replace the existing Pathway environment and preserve the database that is previously installed for the Setup Tool.

   Important! If you are reinstalling the Setup Tool, run the SETSTOP command before reinstalling to ensure its Pathmon process is stopped.

2. (step 1): create the SETUP TOOL Pathway environment requires the following information. For each prompt, press Enter to accept the default value, or specify a new value at the prompt:
   • Pathmon process name for the Setup Tool

     Default: $SET

   • Home Terminal name

     Default: $ZHOME

   • Log device

     Default name: $0

   • PATHTCP2 location for the Setup Tool

     Default: $SYSTEM.SYSTEM

   • Maximum number of installations

     Default: 4

   • Maximum number of simultaneous compilations

     Default: 5

   Note: We recommend that you assign a unique Pathmon process name for the Setup Tool.

   INSTALL copies the $SYSTEM.SYSTEM.PATHTCP2 file to a location designated for the Setup Tool to use. The security vector for this file must allow Implementation Toolset users read access to the file.

Selecting any option other than A returns you to the Setup Tool Install Menu when the installation finishes. Enter Q to exit the installation.

The Setup Tool Install Menu also lists other options to access system resources such as the editor and the spooler.

After finishing the installation procedure, enter Q to exit the install macro.