Install Implementation Toolset Using the INSTALL Macro

Installing CA Gen on NonStop › Install Implementation Toolset Using the INSTALL Macro

Install Implementation Toolset Using the INSTALL Macro

Note: If possible, stop all applications on the volume and subvolume where you will install the Implementation Toolset before running the INSTALL macro.

Follow these steps:

Run the INSTALL macro by entering the following command:
```
run install
```
After a brief introduction to the install procedure, the macro prompts you to specify the volume and subvolume for the IT.
Press Enter to accept the default location, the current $<vol>.<subvol>. To specify another location, enter a volume and subvolume at the following prompt:
```
Implementation Toolset DSV location ($VOL.SUBVOL):
```
The INSTALL macro prompts for the location of the Codepage Translation Tables that Distributed Processing Server applications use. The files are delivered in a packed file that is expanded as part of the installation.
Press Enter to accept the default location, $<vol>.TRANSLAT where $<vol> is the current volume. To select another location, enter a volume and subvolume at the following prompt:
```
Location of the CodePage Translation Tables ($VOL.SUBVOL):
```
Select the customization file, TACLCSTM or TACLLOCL, to update with the call to MAKEHOME. Enter 1 to update your TACLCSTM file, or enter 2 to update the TACLLOCL customization file for all users of the NonStop server.
Note: The added call to MAKEHOME sets the #PMSEARCHLIST environment variable.

After you confirm the selections, the installation proceeds to set the TACLCSTM or TACLLOCL file and to install the translation tables. This may take a few minutes due to the expansion of the packed file containing the Codepage Translation Tables. When it finishes, it continues prompting for site-specific parameters.

Note: Entering no or N to the prompts will not prevent you from using the Setup Tool to install CA Gen applications on NonStop.

The INSTALL macro displays the following prompts:

Do you want to Configure your Site's Pathway Parameters {Y | N}?

Do you want to Configure your Site's Compiler Parameters {Y | N}?
(Optional) Specify to configure the site Pathway parameters and the Compiler parameters. When you enter Y to update the parameters, the INSTALL macro displays the following options:
Default Pathway configuration:
- L - List Configuration
- C - Change Configuration
- R - Return, finished configuring Pathway parameters
Changes to the default Pathway parameters are saved in a file that is named PWYCNFG in the Implementation Toolset DSV location.

Configure Compiler parameters:
- L - List current configuration
- C - Change current configuration
- R - Return, finished configuring Compiler parameters
Changes to the default Compiler parameters are saved in a file that is named OPTCNFG in the Implementation Toolset DSV location.

Enter L to list the current configuration parameters. After reviewing the configuration, enter C to change the parameters. After changing the parameters, enter R to continue the installation.