Configure CA Top Secret

Web Services › How to Enable Security Access to Web Services › Security Software Customization for Web Services › Configure CA Top Secret

Configure CA Top Secret

If your site uses CA Top Secret, you must configure CA Top Secret so that all authorized users can initiate WSEWSSTC correctly as a started task. To configure CA Top Secret, you define a new facility named ENDEVOR, add a new ACID, and give the ACID a MASTFAC definition. You then make this facility the default ACID for the CAICCI-spawned task WSEWSSTC defined by your site's CA Common Services administrator. Finally, you add all users of Web Services to the ENDEVOR facility.

Note: For more information about completing the following steps, see your CA Top Secret documentation or contact Technical Support for CA Top Secret.

To configure CA Top Secret

Define a new facility named ENDEVOR for CA Endevor SCM by adding the following definitions to the CA Top Secret parameter file (specified by the PARMFIELD DD statement):
```
* USERnn FACILITY FOR
*
FAC(USERnn=NAME=ENDEVOR)
```
Define a new ACID named ENDEVOR by entering the following command:
```
TSS CRE(ENDEVOR) NAME('endevor userid') TYPE(USER) FAC(STC,ENDEVOR) PAS(NOPW,0)
```
The NODSNCHK, NORESCHK, and NOSUBCHK bypass attributes on the ENDEVOR ACID may be required. If not, make sure that the ACID is authorized to access all of the files and resources it requires.
Give the ENDEVOR ACID a MASTFAC definition by entering the following command:
```
TSS ADD(ENDEVOR) MASTFAC(ENDEVOR)
```
Assign ENDEVOR as the default ACID for the CAICCI-spawned task WSEWSSTC by entering the following command:
```
TSS ADD(STC) PROCNAME(WSEWSSTC) ACID(ENDEVOR)
```
Grant each user of Web Services access to the ENDEVOR facility by entering the following command:
```
TSS ADD(USERID) FAC(ENDEVOR)
```

Note: For more information about defining a new facility, see your CA Top Secret Control Options Guide. For more information about the CRE and ADD commands, see the CA Top Secret Command Functions Guide.