Previous Topic: How to Create CA Endevor SCM Base, Delta, and List LibrariesNext Topic: How to Add Site Symbolics to Associate Natural with CA Endevor SCM

CA Endevor Integration for the Natural Environment › The Natural Development Lifecycle › How to Configure a Natural Lifecycle in CA Endevor SCM › Edit, Reassemble, and Relink ENCOPTBL

Edit, Reassemble, and Relink ENCOPTBL

To activate CA Endevor Integration for the Natural Environment, you must edit the Optional Features table (ENCOPTBL). As delivered, this option is turned off.

Follow these steps:

  1. Find the ENCOPTBL in use at your site. This table is delivered in the iprfx.iqual.CSIQSRC library. To verify the table in use at your site, you can look in your site's C1DEFLTS table where the table should already be defined using the OPTTBL=parameter.
  2. Find the following line in ENCOPTBL: ENHOPT EINE_ACTIVE=ON and uncomment the line. To find this option in the table, you can go to the command line and type F 'EINE_ACTIVE' and press Enter.
  3. Use the JCL member BC1JTABL in the iprfx.iqual.CSIQJCL library delivered with the product to reassemble and relink ENCOPTBL.

    The ENHOPT_EINE ACTIVE parameter is now active in your site's ENCOPTBL This is a requirement to enable the CA Endevor Integration for the Natural Environment option.

Note: For more information on using the Optional Features Table, see the chapter "Using Optional Features" in the Administration Guide.