CA Endevor Integration for the Natural Environment › The Natural Development Lifecycle › How to Configure a Natural Lifecycle in CA Endevor SCM › How to Add Site Symbolics to Associate Natural with CA Endevor SCM

How to Add Site Symbolics to Associate Natural with CA Endevor SCM

The CA Endevor SCM site symbolics facility enables you define global symbols that can be used in type and processor definitions to reference data set name specifications for base, delta, source output, include libraries, and processors. This simplifies maintenance, because these commonly referenced data sets can be defined in a single location. Perform the following steps to add the site symbolics:

1. Define site symbolics.
   1. Define site symbolics to associate each CA Endevor SCM stage and Natural development system to a specific FUSER and FDIC combination. You can define a maximum of 99 sets of these site symbolics. For more information, see Associate Each CA Endevor SCM Stage to a Specific Natural FUSER/FDIC Combination.
   2. Define site symbolics to associate your Natural libraries to CA Endevor SCM locations. For more information, see Methods of Associating Natural Libraries to CA Endevor SCM Inventory Locations.
2. Use the JCL member BC1JSYMT to create the site symbolics table.
3. Define the site symbolics table in C1DEFLTS using the SYMBOLTBL= parameter to define the table name.

Note: For more information on adding site symbolics to CA Endevor SCM, see the chapter "Site Symbolics" in the CA Endevor Software Change Manager Administration Guide.