Review the MAXCAD value you defined in the IEASYSxx member of your SYS1.PARMLIB. This value limits the number of common data spaces that can be brought up on a single LPAR.
MAXCAD=50, /*permits up to 50 SCOPE=COMMON data spaces
Note: If omitted, the default value for MAXCAD is 25.
Each CADDSPL environment uses:
The total of all data spaces for EACH CADDSPL environment must be added to the total number of data spaces used by other products on that LPAR.
Important! You must reIPL the system after this parameter is changed.
|
Copyright © 2011 CA.
All rights reserved.
|
|