Administration Guide › Set Up the Sample Directories › Set Up the Router Namespace Partition

Set Up the Router Namespace Partition

You have now set up namespace partitions for the Democorp and UNSPSC DSAs. We recommend that you now set up a router partition.

To set up the Routernamespace partition

1. Navigate to the Namespace map.
2. Right-click the c=au node (middle of the tree) and select Add new partition.
3. Enter the following details:

   Partition name

   Specifies the name of the namespace partition that you are creating. This name is used in DXmanager displays.

   Enter: router

   Prefix

   Specifies the context prefix of the DIT that the DSA publishes that it serves.

   Enter: c=au (automatically populated)

   Port

   Specify the port for this namespace partition. The DSAs created when you deploy this namespace partition to a host uses this port as their listen address.

   Enter: 19289

   Console port

   Specifies the port on which the DSA accepts connections from the local computer only. If this is not specified, there is no console for the DSA.

   Enter: 19290 (automatically populated when you enter the Port).

   Remote console port

   Specifies the port on which the DSA accepts connections from remote computers.

   Enter: 19291 (automatically populated when you enter the Port).

   SNMP port

   Specifies the SNMP port for this partition. This is the port the DSA will use to send SNMP traps. This is needed by the DXmanager to be able to monitor DSAs.

   Enter: 19289

4. When you are satisfied with the settings, click Finish.

   The Maps tab appears, showing the Namespace map. It should appear similar to the following:

   

5. Save this version of the configuration, as follows:
   1. Click Configuration, Save.
   2. Enter a comment that describes the current state of the configuration, and then click OK.

   You can now add more hosts to the directory backbone.