Count Calculation Example

Administering › License Administration › Count Calculation Example

Count Calculation Example

The Count calculation for the DevTest Solutions Usage Audit Report is a three-step process.

Each time a concurrency is detected across the enterprise, a group count is recorded for all involved registries. Consider the following example for the Test Power User user group.
For reporting purposes, the group counts with maximum concurrency are used. In this sample example, the shaded rows (1, 3, and 4) are used.

Test Power User

Timestamp	Registry 1	Registry 2	Registry 3	Group Count
1	1	0	3	4
2	0	0	2	2
3	1	2	1	4
4	0	0	4	4
5	1	1	1	3

After identifying the maximum group count data by registry, the average of the counts by registry is calculated. The minimum and maximum count values are stored. These three values (average, minimum, and maximum) appear on the report.

Test Power User

Registry	Count 1	Count 2	Count 3	Avg	Min	Max
Registry 1	1	1	0	0.67	0	1
Registry 2	0	2	0	0.67	0	2
Registry 3	3	1	4	2.67	1	4
TOTAL				4	1	7

This data is summarized on the Overview page of the report as User Type and Count. The Count data that is displayed is combined for each user type. The data is calculated by taking the average of the total Min and Max across the registries in the sample for each user type. The count represents the maximum concurrency for that user type because the sample is composed of only group counts with maximum concurrency.

User Type	Count
Test Power User	4