Reference › Test Case Reference › Test Step Descriptions › Utilities Steps › Audit Step

Audit Step

The Audit step lets you apply an audit document to a current test step, remote test, or virtual service.

This step allows a model to be verified in terms of the events it produces during execution.

To open its editor, click the step.

Mode

This step has two modes:

• Start Monitoring
• Apply Audit Document.

Start Monitoring Mode

If you select the Start Monitoring Mode:

Audit Document

Enter or browse for the audit document.

Target

Select the target for the audit document:

• This Model: Applies to the current model.
• Test Run: Applies to the test run.
• Virtual Model: Applies to the virtual model.

If Environment Error

Specifies the action to take or the step to go to if the test fails because of an environment error.

Default: Abort the test.

Apply Audit Document Mode

If you select the Apply Audit Document mode:

If Audit Fails

Select the step to run if the audit fails.

If Environment Error

Specifies the action to take or the step to go to if the test fails because of an environment error.

Default: Abort the test.