Using CA Application Test › Using the Workstation and Console with CA Application Test › Building Test Cases › Creating Test Cases › Add Test Steps

Add Test Steps

Steps can be added in several ways.

To add a test step:

Do one of the following steps:

• Select Commands, Create a New Step from the main menu.
• Click Add Step from the Test Case toolbar.
• Right-click a step in the workflow and click Add Step After. A step is added right after/below that step.

When a step is inserted into an existing workflow, the steps on either side of the inserted step are updated automatically, keeping the workflow linear.

If the workflow contains branches or loops, the next step is not set automatically.