The Events tab displays the events that are generated during the run.
The Events tab consists of the following panels:
Events to Filter Out
The Events to Filter Out panel enables you to restrict the events that appear during the run. The panel contains a list of events. If the check box for an event is selected, the event does not appear during the run.
The panel includes a drop-down list. The options enable you to filter none of the events, include a predefined set of events, or filter all of the events. The options are as follows:
Note: Under a load test, these UI elements are disabled. For a test case that DevTest determines is a load test, you cannot change the test to send, for example, individual step responses. Sending more than the basic events negates the value of the load test.
Simulators
The Simulators panel shows the status of the simulators in use.
Test Events
The Test Events panel displays the events. The most recent event appears at the top. The oldest event appears at the bottom.
You can list events in real time by selecting the Auto Refresh check box at the bottom of the panel, or you can refresh the list manually by clicking the Refresh icon, with the Auto Refresh box cleared. Only those events that have not been filtered out are displayed.
For each event, the following information is displayed:
The time of the event
The name of the event
The name of the simulator in which the event was generated.
The instance ID and run number (separated by a forward slash)
A short piece of information about the event
A long piece of information about the event (if available)
|
Copyright © 2014 CA Technologies.
All rights reserved.
|
|