Defining Stacked Reports That Contain Exclusive Segments › Defining a Stacked Report Containing Exclusive Segments › Step 7: Specify Identification Text for Report 3

Step 7: Specify Identification Text for Report 3

1. On the Report Definition attributes panel, enter T on the command line and press Enter to display the Report Identification Text subpanel.
2. On the Report Identification Text subpanel:
   1. Enter X under Type.
   2. Leave the (R)eus field blank to specify the default (NO) because you do not want the segment to be used again to select additional pages.
   3. Enter EQ under Op.
   4. Enter 1 under Line.
   5. Enter 28 under Col because the word CHECK (the word you are searching for), starts in the 28th column of line 1 of the data set.
   6. Enter CHECK under Text.
   7. Press Enter.

      CA Deliver ------------- Report Definition Attributes ------ Row 00001 of 00010
      Command ===>                                                  Scroll ===> PAGE
      
        ID     ---> TRJOB02-R03                           Job    ---> TRJOB02   
        Step   --->              Procstep --->            DD     --->       
                                                          Type   ---> STACK
       Report Identification Text:
                    Line     Column
      Sel Typ R Op Beg End Beg   End   Text                              Cols 001 046
          X     EQ 1       28          CHECK
      
      
      
      
      
      ******************************* Bottom of Data ********************************
      
      

   The text CHECK under the header Text is enclosed in single quotation marks (not shown).

3. Enter END on the command line and press Enter to display the Report Definition Attributes panel.

When you exit the Report Definition Attributes panel, the information you entered for report 3 is entered into the database and the message REPORT SAVED is displayed in the short message area.