You can select one or more report identifiers for processing by entering one of the selection codes listed in the following table. Enter the selection code to the left of, and on the same line as, the report identifier to be selected.
An individual report identifier can be selected automatically by placing the cursor on the targeted entry and pressing the Enter key. The selection is equivalent to the S selection code. If a selection code or input command is entered, automatic selection does not occur.
The Reports for Job panel also supports the full range of edit selection codes to copy, delete, insert, move, and repeat entries. For more information, see the section Tabular Commands in the chapter "Basics."
Deletes the report identifier.
Displays the historical data for the report identifier.
"Presets" the handling of the last rerun of previously produced reports that belong to the specified step.
Displays the report definition attributes for the report identifier.
Inactivates the report identifier.
Forcibly inactivates the report identifier.
Important! Use UF only as a last resort to clean up entries in a database because some entries can be left on the spool volumes.
Displays the Distribution Xref for Report panel.
|
Copyright © 2013 CA.
All rights reserved.
|
|