Defining a Distribution List › Defining and Using a Distribution List › Step 2: Define a Job

Step 2: Define a Job

Next you define the job that creates the reports. The name of the job is U90955.

1. On the command line of the Primary Selection Menu panel, enter J, a space and the job name U90955.

    CA Deliver - Primary Selection for DELIVER.SYSTEM1 ----------------------------
    Command ===> J U90955
    
      A Active Display    - Display selection list of active reports or bundles.
      B Bundle Data       - Display bundle data.
      D Distribution Data - Display distribution data.
      J Job Data          - Display job data.
      R Report Data       - Display report data.
    
        Operands for A:
          B    - Display selection list of active bundles.
          R    - Display selection list of active reports (default).
          X    - Limit selection list to exceptions.
          PREV - Display selection list for previous cycle.
    
        Operand for B,D,J,R:
          Omit operand for complete selection list.
          Specify identifier to display data.
          Specify generic identifier for limited selection list.
          L    - For D only, display list of distribution lists.
   
      Enter END command to terminate this CA Deliver session.
   
   

2. Press Enter to display the Reports for Job panel.

   CA Deliver ---------------- Reports for Job: U90955 -------- Row 00001 of 00010
   Command ===>                                                  Scroll ===> PAGE
   
    Desc    ===>
    Prevrun ===>
   
   Sel Stepname Procstep DDname     Report ID                        Type  Prevrun
   
   
   
   
   
   
   
   
   ******************************* Bottom of Data ********************************
   
   

   Note: Both PREVRUN fields shown on the Reports for Job panel work only when CA 11 is installed and set up for use with CA Deliver at your site.