Preparing for Installation › How to Ready the CA SYSVIEW Product Package for Use with CA Cross-Enterprise APM

How to Ready the CA SYSVIEW Product Package for Use with CA Cross-Enterprise APM

CA SYSVIEW is not installed.

Follow the instructions in CA SYSVIEW Performance Management Installation Guide.

CA SYSVIEW is installed.

Verify the status of the CEAPM option, and the DB2 component is enabled, by running the Installation verification program (IVP). Also verify that the CA Insight DPM agent is configured to start.

Note: For information about how to run IVP, see Post Installation Considerations.

Important! The CA SYSVIEW option CEAPM must be set and enabled for CA Cross-Enterprise APM to work with CA SYSVIEW.

To set the CEAPM option

1. Modify the GSVIINST macro parameters in SAMPJCL(INSTALL); remove the “NO” before the CEAPM option.

   , *------------------------------------------------* X
   , * CA SYSVIEW Options                             * X
   , *------------------------------------------------* X
   OPTIONS=(,          Begin option list                X
   NOCAPTURE,          ...option                        X
   NOCICS,             ...option                        X
   NODATACOM,          ...option                        X
   NOIMS,              ...option                        X
   NOMVS,              ...option                        X
   NOMQSERIES,         ...option                        X
   NOTCPIP,            ...option                        X
   CEAPM,              ...option                        X
   NOCHORUS            ...option                        X
   ),                  End option list                  X
   

2. When the installation steps are complete, begin the configuration using the CA SYSVIEW Performance Management Installation Guide. If you are configuring CA SYSVIEW only for CA Cross-Enterprise APM, you only have to run a subset of the jobs.