Upgrade Guide › Upgrading Server and Endpoint Components › Upgrade from CA ControlMinder r12.0 SP1 › Upgrade the Distribution Host (DH) › How to Configure Message Routing Settings › Configure the Names of the Message Queues on the Enterprise Management Server

Configure the Names of the Message Queues on the Enterprise Management Server

In this procedure you define the message routing settings on the Enterprise Management Server. You configure the Message Queue settings on the Enterprise Management Server to identify this Message Queue as the primary server.

To configure the names of the Message Queues on the Enterprise Management Server

1. On the Enterprise Management Server, open the file queues.conf in an editable form. The file is located in the following directory, where ACServerInstallDir is the directory in which you installed the Enterprise Management Server:

   ACServerInstallDir/MessageQueue/tibco/cfgmgmt/ems/data
   

2. Locate the queue named 'queue/snapshots' and add the word 'global' after the word 'secure' at the end of the queue name, as follows:

   queue/snapshot secure, global
   

3. Locate the queue named 'queue/audit' and add the word 'global' after the word 'secure' at the end of the queue name, as follows:

   queue/audit secure, global
   

4. Locate the queue named 'ac_endpoint_to_server' and add the word 'global' after the word 'secure' at the end of the queue name, as follows:

   ac_endpoint_to_server secure, global
   

5. Locate the queue named 'ac_server_to_endpoint' and add the word 'global' after the word 'secure' at the end of the queue name, as follows:

   ac_server_to_endpoint secure, global
   

6. Save and close the file.

Note: For information about message routing, refer to the TIBCO Enterprise Message Service User's Guide. Tibco documentation is installed as part of the Message Queue and is located at ACServerInstallDir/MessageQueue/tibco/ems/5.1/doc.