Upgrade Guide › Upgrading Server and Endpoint Components › Upgrade from CA ControlMinder r12.0 SP1 › Upgrade the Distribution Host (DH) › How to Configure Message Routing Settings
How to Configure Message Routing Settings
When working in an environment that consists of a single instance of the Enterprise Management Server and multiple Distribution Servers, you must configure the MQ routing settings on all the Distribution Servers to point to the MQ on the Enterprise Management Server. This helps ensure that all the messages that the CA ControlMinder endpoints send are ultimately routed to a single MQ, that is located on the Enterprise Management Server.
To route messages from the MQ on every Distribution Server to the Enterprise Management Server, do the following:
- On each Distribution Server in your enterprise, do the following:
- Stop the Message Queue service.
- Modify the routing to the Enterprise Management Server Message Queue.
- Define the parameters of the Enterprise Management Server Message Queue.
- Configure the names of the Distribution Server message queues.
- Specify the location of the Enterprise Management Server Message Queue.
- Start the Message Queue service.
- On the Enterprise Management Server, do the following:
- Stop the Message Queue service.
- Modify the routing to the Distribution Server Message Queue.
- Define the parameters of the Distribution Server Message Queue.
- Configure the names of the Enterprise Management Server message queues.
- Specify the location of the Enterprise Management Server Message Queue.
- Start the Message Queue service.
Note: For information about message routing, refer to the TIBCO Enterprise Message Service User's Guide. Tibco documentation is installed as part of the Message Queue and is located at ACServerInstallDir/MessageQueue/tibco/ems/5.1/doc.
Copyright © 2013 CA Technologies.
All rights reserved.
|
|