The following CA Directory errors may appear:
Directory DSA Will Not Start
If a Directory DSA will not start, you can attempt to start it in debug mode using the following command:
dxserver -d start <dsaname>
This command provides you with any error messages resulting from the failed start. These messages are also available in the log files in the following directory:
/opt/CA/Directory/dxserver/logs.
How to Enable Tracing
To enable tracing, edit the configuration files in the following directory:
/opt/CA/Directory/dxserver/config/logging
Note: For more details about tracing, refer to CA Directory documentation.
How to Review the Most Common DSA Settings
To review the most common DSA settings, view the files pertaining to the DSA in the following directory:
/opt/CA/Directory/dxserver/config/knowledge
How to Review any Schema Issues
To review any schema issues, view the files in the following directory:
/opt/CA/Directory/dxserver/config/schema
|
Copyright © 2013 CA.
All rights reserved.
|
|