CADSMCMD Command Line Interface › cadsmcmd Commands › compgroup—Computer Group Management › General Group Management › showAttr—Show Attributes of Computer Groups

showAttr—Show Attributes of Computer Groups

This action allows you to list the attributes of computer groups.

This action has the following format:

compgroup action=showattr 

name=group_name
[groupScope={global | local}]

name

Specifies the name of a computer group of which the attributes are listed.

groupScope

Specifies the scope of the group specified. The following values are valid for this option:

Global

The group is a global group, created at an enterprise manager. It may be replicated to a domain manager.

Local

Specifies a local group, created at the domain manager the CADSMCMD is connected to.

If "groupScope" is not coded then the CADSMCMD first tries to locate the group as a local group. If this fails then it is tried to locate the group as a global one.

Note: For a template group the method is mapped to the templategroup action showattr This action shows the attributes of the specified software template..