CA AuthMinder UNIX Installation Guide › Upgrading to Release 7.1.01 › Upgrading to 7.1.01 › Reinstall Strong Authentication › How to Reinstall Strong Authentication on a Single System

How to Reinstall Strong Authentication on a Single System

Perform the following tasks to reinstall Strong Authentication on a single system.

Important! The information in these sections apply to a fresh installation of Strong Authentication.

Use the database that you migrated earlier during the upgrade operation. Install Strong Authentication at the same location where the older release is installed. If you install in a different location, the Strong Authentication Server will not start.Perform Complete Installation

Complete the following steps:

1. Verify the Database Setup
2. Prepare Your Application Server
3. Deploy CA Advanced Authentication
4. Verify CA Advanced Authentication
5. Start Strong Authentication Server
6. Verify the Installation

   Note: If there is any warning during Server startup or while verifying the installation and transactions fails, then the upgrade has not been performed successfully. Use the information given in Troubleshooting Issues During Upgrade. If that does not help, revert to your initial setup by following the steps that are listed in Reverting to Your Initial Setup.

7. Deploy User Data Service
8. Deploy Sample Application
9. Use Sample Application
10. Perform Additional Configurations for CA Adapter 2.2.7
11. Post-Installation Checklist