To reinstall CA Strong Authentication on a single system, perform the following tasks.
Important! The information in these sections apply to a New Installation of CA Strong Authentication.
Use the database that you migrated earlier during the upgrade operation. Install CA Strong Authentication at the same location where the older release is installed. If you install in a different location, the CA Strong Authentication Server will not start.
Follow these steps:
Note: If there is any warning during Server startup or while verifying the installation and transactions fails, then the upgrade has not been performed successfully. Use the information given in Troubleshooting Issues During Upgrade. If that does not help, revert to your initial setup by following the steps that are listed in Reverting to Your Initial Setup.
|
Copyright © 2014 CA Technologies.
All rights reserved.
|
|