The control statements for TMSAUDEX are designed for use when the program is run as part of a TMSXTEND function. When run in standalone mode TMSAUDEX will always attempt to report on all systems found in the Audit file. If specified, the INCLUDE and EXCLUDE control statements are only verified for proper syntax.
Following is a complete discussion on using the INCLUDE and EXCLUDE statements associated with running the TMSXTEND utility.
This control statement defines the 4-byte SMF id of systems running CA 1 that should be excluded from processing by TMSXTEND. EXCLUDE must begin in column 1 followed by a blank and then the SMF id. Only one SMF id may be specified per control statement. Note that failure to find a system specified on an EXCLUDE statement is not considered an error. TMSAUDEX will continue to process and complete with a RC=0. You should never exclude a system that is active and using TMC that you are extending.
This control statement defines the 4-byte SMF id of a system running CA 1 that should be included in the list of systems to process when performing an extend function. INCLUDE must begin in column 1 followed by a blank and then the SMF id. Only one SMF id may be specified per control statement.
Note: This utility supports comment statements that begin with an asterisk (*) in column 1; however, they are not listed in any report. Comments may also be placed on the INCLUDE and EXCLUDE statements after column 21.
|
Copyright © 2013 CA Technologies.
All rights reserved.
|
|