Previous Topic: Set Up the Build ToolNext Topic: Pre-Code Generation Tasks

DDL Generation › Using the ODBC/ADO.NET Technical Design › Performing DDL Generation

Performing DDL Generation

Use the following procedure to perform the DDL generation and installation:

Follow these steps:

  1. Start the CA Gen Workstation Toolset
  2. Open the model.
  3. Open the Technical Design Diagram.
  4. Select and open the ODBC/ADO.NET Technical Design.
  5. If necessary, perform transformation or retransformation to synchronize the logical and physical data models.
  6. Open the Generation Diagram.
  7. Open the Generation Defaults dialog. Set the generation parameters:
  8. Perform the DDL Generation and Installation.