XCMH202W

XCOM Default Table indicates that IBM APAR OA23740 has not been applied. No USS transfers will be permitted.

Reason:

IBM_APAR_OA23740=NO was specified or defaulted in #DFLTAB. This exception only applies to CA XCOM Data Transport regions running on operating system levels below z/OS 1.10.

Action:

This message is issued by the CA XCOM Health Check exit, which examines the value of the IBM_APAR_OA23740 in the Default Options Table. The following actions and responses are documented for this check:

System Action:

The system continues processing, but without the ability to transfer USS files.

Operator Response:

None required.

Problem Determination:

Determine if IBM APAR OA23740 has been applied. If so, then change the value in the XCOM Defaults Table (#DFLTAB) to YES.

System Programmer Response:

Determine if IBM APAR OA23740 has been applied. If so, then change the value in the XCOM Defaults Table (#DFLTAB) to YES.

Source:

CA XCOM Data Transport module XCOMXFER

Reference Documentation:

See the following guides:

CA XCOM Data Transport for z/OS Administration Guide
CA XCOM Data Transport for z/OS Message Reference Guide (message XCOMM0843E)