|
|
|
The following operands are used with the TRACE command:
Indicates that all active sessions involving this system are to be traced.
F XCOM,TRACE,* (with the asterisk operand) and
F XCOM,TRACE (without an operand) are equivalent.
Specifies the name (one to eight characters) of the LU to be traced. An LU name can be traced before a session exists. There is no requirement that the LU be defined to allow CA XCOM Data Transport to initiate a trace.
The optional keyword SNA should be used in cases where the LUNAME and IPNAME are the same at a site. This forces the LUNAME to be treated exclusively as SNA when creating the trace file.
Specifies the name or address of the IP destination to be traced.
Specifies the level of tracing desired. Valid levels are 0 through 9, with 0 providing the least and 9 providing the most trace data.
| Copyright © 2012 CA. All rights reserved. |
|