The Remote Spooling Feature (Process SYSOUT) › Process SYSOUT Enhancements › Using PSOWAIT

Using PSOWAIT

The PSOWAIT option can be used to control whether output is taken from the JES spool immediately and held in temporary data sets (PSOWAIT=NO) or whether output is allowed to remain on the JES spool until a session is available to transmit it on.

PSOWAIT=NO is the default value. Specify NO if:

• The remote LU is on a leased line.
• There are less than 100 nodes in the Destination Table.
• The destination is an IP address.

PSOWAIT=YES prevents CA XCOM Data Transport from scanning the JES spool if a session to send the data on does not exist. To reduce system overhead, specify PSOWAIT=YES if there are more than a 100 nodes in the Destination Table. Otherwise, specify NO.

For a description of the PSOWAIT parameter, see the CA XCOM Data Transport for z/OS Administrator Guide.