The Batch Interface › PARM Parameters › COMPNEG

COMPNEG

Specifies whether compression negotiation is performed.

YES

Specifies that the data compression method is negotiated.

NO

Specifies that the data compression method is not negotiated.

Notes:

• If COMPNEG=YES and the compression method suggested by the initiator or partner LU is known to both participants, that method is used to compress the transfer data.
• If the suggested compression method is not known to a participant involved in the transfer, Run‑Length Encoding of blanks and zeros (that is, COMPRESS=YES-see the next section) is applied to the data to be transferred.
• If an unknown compression type is requested, the file transfer is rejected.

Default: YES

CONFIG

This parameter indicates the name of the TYPE=CONFIG control library member that is read and CA XCOM Data Transport server uses.

XCOMDFLT

Specifies the TYPE=CONFIG member XCOMDFLT.

xxxxxxxx

Specifies the name of the TYPE=CONFIG member other than XCOMDFLT. This name can be up to eight alphanumeric characters long.

Notes:

• If both the DFLTAB and CONFIG parameters are specified, the CONFIG parameter takes precedence.
• Using the CONFIG parameter assumes that the member named is an existing, valid TYPE=CONFIG member.

Default: XCOMDFLT