Operation and Control › Using the MODIFY Commands › CANCEL Command › Operands

Operands

The following operands are used with the CANCEL command:

* (asterisk)

Cancels all active sessions.

destname

Cancels the specific session associated with the designated CA XCOM Data Transport partner (destination).

The CA XCOM Data Transport partner can be identified with any one of the following:

• A valid SNA LU name
• A TCP/IP name
• A TCP/IP address.

The CA XCOM Data Transport partner name (destname) must match that which is shown by the DISPLAY command.

If there is no active session with the partner, an error message is displayed.

IMMED

Cancels the session immediately, causing the transfer to be interrupted and requeued. It is automatically retried after the error interval expires if GETSESS=YES is specified, or when the session becomes available if GETSESS=YES is not specified.

PURGE

Cancels the session immediately, causing the transfer to abort. The transfer is terminated unconditionally, that is, it cannot be restarted but must be rescheduled from the beginning.

SUSPEND

Cancels the session immediately, causing the transfer to be interrupted and suspended. The transfer remains suspended until it is reactivated with the RESUME command.