Using CA XCOM Data Transport › Start CA XCOM Data Transport

Start CA XCOM Data Transport

Before you can use CA XCOM Data Transport to perform transfers, the XCOMD CA XCOM Scheduler service must be running. For a procedure for starting the XCOMD CA XCOM Scheduler service, see the CA XCOM Data Transport for UNIX and Linux Installation Guide.

To start the CA XCOM Data Transport GUI, run the following command:

$XCOM_HOME/bin/StandaloneUI.sh

Note: This is the full path name specification for StandaloneUI.sh. Make sure that the XCOM_HOME environment variable is set to the XCOM installed location.

Note: For starting and stopping the CA XCOM Data Transport GUI, ERRORLEVEL has no meaning. When executing the command-line programs (xcomtcp.exe and xcom62.exe), the ERRORLEVEL indicates successful or failed processing. An ERRORLEVEL of ZERO indicates successful operation and termination. An ERRORLEVEL of NON_ZERO values indicates program processing was not successful, and that the program has terminated.