|
|
|
When you have activated the XCOMXFER server and specified the START parameter, you can start CA XCOM Data Transport.
To start CA XCOM Data Transport
Enter one of the following commands on the z/OS console (or any TSO/ISPF or NETVIEW session) where the user is authorized to invoke z/OS system commands:
Several informational messages are displayed when CA XCOM Data Transport is started, as shown in the following example:
XCOMM0672I CA XCOM(TM) DATA TRANSPORT (R) RELEASE r11.6 - GENERATION LEVEL 0410 SPO0 XCOMM0004I START=STARTB0 XCOMM0004I DFTLAB=XCLSDFB0 XCOMM0004I ACBNAME=XCOMLS XCOMM0008I XCOMLS ACB OPENED SUCCESSFULLY XCOMM0009I COMPILED UNDER VTAM V6 R1 M2 - EXECUTING UNDER VTAM V6 R1 M2 5695-117 XCOMM0763I DEFAULT TABLE XCLSDFB0 LOADED. GENERATED 11/28/04 AT 09.07 XCOMM0027I ESTAE ROUTINE HAS BEEN ESTABLISHED XCOMM0037I PSO SUBTASK ATTACHED SUCCESSFULLY XCOMM0056I CA XCOM(TM) RELEASE r11.6 (GEN LEVEL 1203 SPO0) IS UP AND ACCEPTING LOGONS XCOMM0330I PRIMARY SUBSYSTEM IS JES2 XCOMM0803I STARTING XCOM TCP/IP LISTENER XCOMM0788I XCOM TCP/IP LISTENER IS ACTIVE ON PORT 8044, IP ADDRESS=
As it initializes, CA XCOM Data Transport issues one XCOMM0559I message for each member that is enabled, as shown below:
XCOMM0559I AS400 ENABLED SUCCESSFULLY XCOMM0559I MVSPAR ENABLED SUCCESSFULLY
| Copyright © 2012 CA. All rights reserved. |
|