Configuration Parameters › Destination Parameters for Single LUs, Groups of LUs, and Single IPNAMEs › SETUP

SETUP

Specifies whether CA XCOM Data Transport should pass the SYSOUT print and class values from the JES queue to the remote system.

YES

Indicates that either the JCL parameter values specified by the user or the JES‑assigned default values are passed.

For information about coding SETUP=YES with a VAX system, see the Notes section that follows.

NO

Indicates that print class and form values of binary zeroes (nulls) are passed to the remote system.

For information about coding SETUP=NO with a VAX system, see the Notes section that follows.

Default: YES

Notes:

• The SETUP parameter is referenced only for transfers that use the Process SYSOUT interface.
• Specify SETUP=YES only if you are sure that all the form names and print class values passed to the remote system are valid on the remote system.
• Specify SETUP=NO if the Process SYSOUT interface is being used to communicate with a VAX system. VAX systems require every form name used to be predefined; invalid form names will cause the print job to ABEND. In a case where the VAX site does require special forms, specify SETUP=YES, ensuring that all the z/OS form names and print classes have been predefined to the partner VAX.