Shutting Down

This section describes how to shut down CA XCOM Data Transport for Oracle Solaris 64 before performing an upgrade or a reinstall.

Note:

You must log on as a superuser (root), or as a member of the xcomadm group, to perform this procedure.
The CA XCOM Data Transport for Oracle Solaris 64 daemon must still be running to execute the command in Step 1.

Important! The command in Step 1 removes all active transfer entries.

Follow these steps:

At the command line, enter the following command:
```
xcomqm -Rf*	
```
All queue entries are deleted.
Close xcomtool, if the GUI is active. Close the GUI by clicking the X in the upper right hand corner.
Enter the following command:
```
xcomd -s
```
CA XCOM Data Transport for Oracle Solaris 64 shuts down, and the following messages are displayed:
```
XCOMU0079I xcomd: stop requested.
```
```
XCOMU0082I xcomd: stop request accepted.
```
Note: If you are working from the console, a message similar to the following also displays:
```
2009/02/22 17:08:49 PRG=XCOMD PID=22189 XCOMU0089I xcomd ended
```