Shutting Down

This section describes how to shut down CA XCOM Data Transport for Linux PC before performing an upgrade or a reinstall.

Notes:

You must log on as a superuser (root), or a member of the xcomadm group, to perform this procedure.
The CA XCOM Data Transport daemon must still be running to execute the command in Step 1.

Important! The command in Step 1 removes all transfer entries that are active.

To shut down

At the command line, enter the following command:
```
xcomqm -Rf*	
```
All queue entries are deleted.
If xcomtool or the GUI (r11.5 and higher only) is active, then they need to be closed. To close xcomtool, click in the Main window and select Quit from the menu bar. To close the GUI, click the X in the upper right hand corner.
Enter the following command:
```
xcomd -s
```
CA XCOM Data Transport shuts down, and the following messages are displayed:
```
XCOMU0079I xcomd: stop requested.
```
```
XCOMU0082I xcomd: stop request accepted.
```
Note: If you are working from the console, a message similar to the following also displays:
```
2009/02/22 17:08:49 PRG=XCOMD PID=22189 XCOMU0089I xcomd ended
```