Reason:
The NCFNODE= parameter was specified but NCF is not installed. This is a serious error that will cause a return code of 8. This message can also be issued if you specify a CA7= parameter value other than CA71.
Action:
If NCF routing is not required, remove the NCFNODE= parameter and rerun the job. If NCF routing is wanted, verify the NCF installation. Note, that beginning with CA WA CA 7 Edition r11, NCF can only be used by the CA71 instance. If you have specified the CA7= parameter, it must equal CA71.
For information about installing and verifying the NCF component, see the Interface Reference Guide.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|