Reason:
The use of XCF was specified, but ICOM could not contact CA WA CA 7 Edition through XCF. WIP stands for "where in place" in the ICOM program the WTO is issued. The following values for WIP give further explanation:
Indicates the SMF tracking data is being written to the XCF data set and continues until the data set is full.
Indicates the data is being buffered in CSA, and the message is reissued every minute.
Indicates ICOM has lost communication with CA WA CA 7 Edition. The message is issued once a minute for two minutes. If, by the end of that time, ICOM still cannot communicate with CA WA CA 7 Edition, ICOM turns off the use of XCF to communicate with CA WA CA 7 Edition.
Indicates ICOM has determined that CA WA CA 7 Edition has just joined the XCF group, but CA WA CA 7 Edition is not communicating properly with ICOM. The message is issued once a minute for two minutes. If, by the end of that time, ICOM still cannot communicate properly with CA WA CA 7 Edition, ICOM turns off the use of XCF to communicate with CA WA CA 7 Edition.
Action:
Determine the cause of the message. Usually, CA WA CA 7 Edition is not active or was not started specifying the use of XCF. If necessary, contact either your local systems programmer or your installation specialist for assistance.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|