AFM - CA7R Messages › BSTR Messages › BSTR-16

BSTR-16

CA-7 UNABLE TO START BATCH TERMINAL

Reason:

Any of the following conditions may cause this message:

• The PARM value on the SASSBSTR execute statement specified a relative batch terminal that does not exist (for example, PARM=7 was specified but only four batch terminals are defined in the product's initialization file).
• The control record in the Communications data set indicates the specified batch terminal is already in use. This may be due to an erroneous RESET reply to the CA-7.252 WTOR, or a /START may have been issued from a CA WA CA 7 Edition terminal.
• No batch terminals are defined to CA WA CA 7 Edition.

Action:

If the PARM value is invalid, correct and resubmit the Batch Terminal Interface job. If a RESET reply was inadvertently entered or if a /START was issued, make sure that data center personnel understand the proper use of these commands. There should be no problem in rerunning the interface job.