OUT Command

The OUT top line command indicates the completion of a workstation task. The OUT command, which is used after an IN command, uses a reference number for identifying each station. CA WA CA 7 Edition generates the reference number each time the network enters the queue. This number can be obtained by doing an LPRE or LPOST command. This function is available as the O option on the QM.6 and QM.7 panels.

This command has the following format:

OUT,REF={nnnnrrs|(nnnnrrs,...)}

REF

Identifies the workstation network tasks to log out.

Limits: 4 to 7 numeric characters

nnnnrrs

Identifies a single workstation reference number.

Note: Reference numbers can be obtained by using the LPRE or LPOST commands.

nnnn: CA 7 job number. You can omit leading zeros.
rr: Relative sequence of the network in relation to other networks associated with the job. For input workstation networks, the value is 00. You cannot omit leading zeros.
s: Relative position of the station within the network. The first station is position 1.

(nnnnrrs,...,nnnnrrs)

Identifies up to ten reference numbers. Must be enclosed in parentheses.