Commands › UT.13 - Display Format 1 DSCB Panel › Examples

Examples

The following display shows the VOLSER value even if it was not entered originally. Below the two heading lines, the 101 bytes beginning at offset hex '2C' in the DSCB are shown in both hexadecimal and character form. The PROGRAM value at the bottom of the panel indicates UTL1 because that module accessed and formatted the DSCB information.

 ------------------  CA-7 UTILITIES - DISPLAY FORMAT 1 DSCB --------------------
 FUNCTION ===>          (LEAVE BLANK EXCEPT TO TRANSFER)


 DSNAME: SYS2.PROCLIB
          (REQUIRED)

 VOLSER: 123456  (REQUIRED IF NOT CATALOGED)

 DATASET CONTROL BLOCK INFORMATION:
     OFFSET   -------------- H E X --------------   --- CHARACTER ----
     00002C   F1000004 5900A500 01560144 00000001   *1...............*
     00003C   0000E2E3 D6C2C9F0 F140FF91 40164D5A   *..STOBI01 .. ...*
     00004C   00021100 54460200 90000C30 00500000   *................*
     00005C   0080C000 0000007E 06888000 00810001   *................*
     00006C   91000001 9A000E00 00000000 00000000   *................*
     00007C   00000000 00000000 00000000 00000000   *................*
     00008C   00000002 01                           *.....           *


 PROGRAM: UTL1   MSG-INDX:      -- UT.13    --  YY.DDD / HH:MM:SS
 MESSAGE: