Starting with r11.3, the coupling facility of ICOM is no longer supported. Customers must use the communication data set (COMMDS) to send data from ICOM to CA Workload Automation SE. A new option for job feedback data exists through XCF.
Prior to this release, SASSICOM startup parameter data could contain a one-byte positional parameter for the ICOM coupling facility. Starting with r11.3, if this parameter is found when ICOM starts, warning message CAL2XC25W is generated. The message states that the coupling facility is no longer supported, the parameter is being ignored, and that the customer should change the startup parameter list. To eliminate this informational WTO requires changing the ICOM execution parameter to remove the CF=N parameter.
Note: For more information, see the Systems Programming Guide.
|
Copyright © 2013 CA Technologies.
All rights reserved.
|
|