

SLFA - SPOR Messages › SMxx › SM71-01
SM71-01
xx INVALID MACRO RETURN CODE nnnn
Reason:
The following explains the various situations:
- If xx=67, nnnn=0004, and the error occurs as a result of adding or saving schedules, then the probable cause is the absence of the ZERO member in the Dataset data set. This can occur if the Dataset data set was reinitialized after the original installation of CA Workload Automation SE.
- If xx=B7, nnnn=0001, and the error occurs as a result of fetching a schedule member with a MEMBER NOT FOUND message, then this may relate to the absence of the ZERO member as described above (xx=67, nnnn=0004).
- If nnnn=0000, the Dataset data set may be out of space.
- If xx=J7, nnnn=0A62, check that the Dataset data set has available space.
Action:
Perform the following actions:
- Use SASSBK00 to back up and reload the database.
- Check for the existence of the ZERO member in the dataset data set using DUMP,DSNBR=SJ0 (SI0, SO0).
- Do a restore of the database (job, dataset and index data set) to the most current, correct copies if the dataset data set has recently been reinitialized in error.
- Contact your installation specialist if no backup exists.
Copyright © 2015 CA Technologies.
All rights reserved.
 
|
|