Reason:
A sequence error occurred in the LOGIN data set. Due to the way date/time range logic is applied, the input data must be in ascending date/time sequence. A U0001 abend follows this message.
This error can occur if an extract is attempted against an active Log data set; that is, one to which CA Workload Automation SE is currently writing. Since reading stops once the THRU value is reached, undetected sequence errors may exist beyond that date/time.
Action:
Determine cause of sequence error, sort the data if necessary, and retry. If an active log is needed, perform a /SWAP command to begin recording on the alternate Log, and run again. Be sure to always use the SASSHIS5 program to dump the log files.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|