Reason:
The following shows the values of x:
An error condition was encountered in the SLOG macro.
An invalid request has been issued for the SLOG macro.
An active buffer could not be found for the Log data set. Most likely the buffer status area of memory has been overlaid.
An I/O error was encountered on the Log data set.
Issued by SASSLOGM.
Action:
When x equals:
Contact your installation specialist for assistance.
Contact your installation specialist for assistance.
Cancel CA Workload Automation SE with a dump and then use the emergency restart (TYPE=ERST) procedure to reinitialize CA Workload Automation SE. Contact your installation specialist when the dump is available.
CA Workload Automation SE abends with a U0750. If the I/O error is permanent, it is necessary to move the Log data set. When the error has been corrected, CA Workload Automation SE should be reinitialized using the emergency restart (TYPE=ERST) procedure.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|