CA-7.000 - CA-7.1044 › CA-7.500 Through CA-7.593 › CA-7.579

CA-7.579

ICOM [(TRAILER)|(SUBMIT)|(SMF)] SUBTASK WAITING FOR xxxx SECONDS. CODE= y[y]

Reason:

A subtask of ICOM has been waiting for xxxx seconds for the Communications data set. The location in the subtask module where the wait occurred is indicated by y:

• If y=A, ICOM is trying to get control of the Communications data set to submit a job.
• If y=B, ICOM is trying to post to the Communications data set.
• If y=00, the Communications DSN is busy.
• If y=04, the Communications data set is full.
• If y=08, the NCF Communications data set is busy.

Issued by SASSJES2 and SASSJES3.

Action:

This could indicate that the Communications data set is on a high-access disk pack; better response is provided if it is on a low-access pack. If the message persists, cancel ICOM with a dump. When the dump is available, contact CA Support at ca.com/support for assistance.