Reason:
The control record in the Communications data set indicates the specified batch terminal is already in use. The value of n denotes the batch terminal number being used. Issued by SASSBSTR.
Action:
The status of the batch terminal can be determined by entering /DISPLAY,T=batchtermname. Reply should be as follows:
If the batch terminal is truly busy, (SKIP status).
If the status display indicates that the terminal is BUSY (SKIP status) and you do not want to wait for the completion of the job currently using the Batch Terminal.
If the status display indicates the terminal is stopped. CA Workload Automation SE will reset the status indicated in the Communications data set allowing the job to run. A previous BTI job was probably canceled.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|