Reason:
The NCFNODE= parameter was specified but NCF is not installed. This is a serious error that will cause a return code of 8. This message can also be issued if you specify a CA7= parameter value other than CA71.
Action:
If NCF routing is not required, remove the NCFNODE= parameter and rerun the job. If NCF routing is wanted, verify the NCF installation. Note, that beginning with CA Workload Automation SE r11, NCF can only be used by the CA71 instance. If you have specified the CA7= parameter, it must equal CA71.
For information about installing and verifying the NCF component, see the Interface Reference Guide.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|