Reason:
Dynamic location of CA Workload Automation SE is attempted if *AUTO* is specified for the CA Workload Automation SE CCI Node parameter/variable. The CA Workload Automation SE CAICCI Interface could not locate a CA Workload Automation SE CAICCI XTM receiver that matches the CA Workload Automation SE XTM identifier (CA-7 xxxx) at any CCI node that is connected to the local environment. The CA Workload Automation SE CAICCI Interface call fails. If message CAL2C405I follows this message, no action is necessary.
Note: For more information about situations where the CA Workload Automation SE instance value can be automatically substituted, see the CAICCI interface in Interface Reference Guide.
Action:
Check to see if the correct CA Workload Automation SE XTM identifier (CA-7 xxxx) is specified or defaulted to for the targeted copy of CA Workload Automation SE. If so, check to ensure that CA Workload Automation SE is active and the CA Workload Automation SE XTM receiver is enabled (check CA Workload Automation SE messages prefixed with CA-7.XTM in the CA Workload Automation SE address space). If so, check to ensure that the local CAICCI system is connected to the CAICCI system on the image where the target CA Workload Automation SE is executing (check the local CAIENF started task). Correct the errors and reissue the commands/job.
|
Copyright © 2015 CA Technologies.
All rights reserved.
|
|