CA Workload Automation SE provides a user exit to control the use of this command.
This command does not remove data sets from the CA Workload Automation SE database.
A DD statement of the following form must exist in the CA Workload Automation SE JCL for each volume to be accessed:
//U7volser DD UNIT=uuuuuuuu,DISP=SHR,VOL=SER=xxxxxx
The ddname is U7 followed by the volume serial number (volser). An ALLOC command or function 11 on the UT Menu panel can be used if the needed DD statement was not included in the JCL.
|
Copyright © 2013 CA Technologies.
All rights reserved.
|
|