The /DRCLASS command adds or removes a disaster recovery class from the list of active disaster recovery classes. Disaster recovery classes have no impact on CA Workload Automation SE processing unless CA Workload Automation SE is running in disaster recovery mode.
Changes to the active disaster recovery class list are not saved across restarts of CA Workload Automation SE. To make a disaster recovery class active when CA Workload Automation SE starts, add the class to the DRCLASS initialization file statement.
Use /DISPLAY,ST=DR to display the list of active disaster recovery classes.
This command has the following format:
►►─ /DRCLASS ─ ,CLASS=(xx1,...,xx8) ─┬─────────────────────┬──────────────────►◄ └─ ,ACT= ─┬─ ADD ◄ ─┬─┘ └─ DEL ───┘
Defines one to eight disaster recovery classes to be added to or removed from the list of active disaster recovery classes. Each disaster recovery class can be one to eight characters long. The disaster recovery classes must be separated by commas and enclosed in parentheses. If a single disaster recovery class is specified, the parentheses can be omitted.
(Optional) Defines the action to perform on the disaster recovery classes specified on the CLASS keyword. ACT=ADD adds the classes to the list of active disaster recovery classes. ACT=DEL removes the classes from the list. If ACT is not specified, the classes are added to the active disaster recovery list.
|
Copyright © 2013 CA Technologies.
All rights reserved.
|
|