The LPDS command lists a card-image member of a partitioned data set (PDS) or a sequential data set. This command enables the user to review data in any PDS or sequential data set. Other commands are also available to review JCL or PARM statements.
Note: Any undisplayable hexadecimal characters in the member are shown as periods (.) in the output from the LPDS command.
This command has the following format:
►►─ LPDS ─ ,DSN=dsname ─┬───────────────┬─┬──────────────────┬────────────────►◄ └─ ,MEM=member ─┘ └─ ,VOLSER=volume ─┘
Defines the fully qualified data set name of either a sequential data set or the name of a PDS containing a member (MEM) to be listed.
Limits: 1 to 44 alphanumeric characters
Specifies that member of a named PDS (DSN) is to be listed.
Limits: 1 to 8 alphanumeric characters
Required: Yes, if listing from a PDS
(Optional) Specifies the DASD volume on which the data set (DSN) resides. If VOLSER is omitted, the data set must be a cataloged data set.
|
Copyright © 2013 CA Technologies.
All rights reserved.
|
|