The RESCHNG command in a CA Workload Automation SE trailer step frees tape drives that are no longer needed. When workload balancing is scheduling jobs, the high-water mark for tape drives is reserved until job completion, unless this command is used. Using this command, the trailer step can be inserted in the job anytime after the maximum number of tape drives is no longer needed.
Note: Because cross-platform jobs do not use any tapes drives or data sets, this command has no effect for cross-platform jobs.
This command has the following format:
►►─ RESCHNG ─┬────────────────┬─┬────────────┬─┬────────────┬─────────────────►◄ └─ ,JOB=jobname ─┘ └─ ,TP1=nnn ─┘ └─ ,TP2=nnn ─┘
Indicates the name of the job to which the change applies. The job must be in the active queue. JOB is required unless the command is entered from SASSTRLR (trailer step).
Limits: 1 to 8 alphanumeric characters
Required: Yes, unless command is from SASSTRLR
(Optional) Indicates the maximum TAPE1 requirements for the remainder of the job.
Limits: 1 to 3 numeric characters from 0 to 255
(Optional) Indicates the maximum TAPE2 requirements for the remainder of the job.
Limits: 1 to 3 numeric characters from 0 to 255
|
Copyright © 2013 CA Technologies.
All rights reserved.
|
|